kdFi V1.4 PNP BMW M52

The kdFi V1.4 is installed in a Siemens compatible enclosure and loaded with an initial setup for M52 engines.
Also note our new and further developed product: UAB BMW M52
The control unit can be used on the M52B20, M52B25 as well as on the M52B28 as a replacement for the following DME Siemens:
MS41.0
MS41.1
If your number is not listed, please contact us, using the contact form.

Customer to do:
– Change Engine Management
– START ENGINE!
– do your own setup

This product is only street legal with special permission in most countries.
Please check local laws before using on official streets.
Automatic transmissions are currently not supported.

Features:
– Alpha-N based setup (can be changed to MAP sensor via software)
– also suitable for turbo and compressor conversions
– full compatible to MSextra Software
– build your own setup
– MS2 onboard / Firmware MS2extra
– Fuel Table 16×16
– Ignition Table 12×12
– USB Connector
– Wideband lambda controller (www.breitband-lambda.de)
– supports stock coils and injectors
– supports stock idle valves
– user programmable relay output
– electronic boost control
– supports CAN Bus
– compatible with the Lambda Sensor LSU 4.2

Scope of delivery:
– kdFi V1.4 Plug and Play ECU
– USB Cable
– kdFi Manual
– from 01.05.24 no CD included, download software CD under available downloads ( HERE )