kdFi V1.4 PNP VW 2H (1,8l)

The kdFi V1.4 is installed in a VW housing and loaded with an initial setup for 2H engines.
The MAP sensor is good up to 1.5 bar boost and can be replaced by a 3 bar sensor if needed.

Customer to do:

• Change engine management

• START ENGINE!

• Do your own setup

This product is only street legal with special permission in most countries. Please check local laws before using it on public roads.

Features:

• MAP sensor-based setup (optimal for turbo conversions)

• Fully compatible with MSextra software

• Build your own setup

• MS2 onboard / Firmware MS2extra

• Free software / open source

• Fuel table 16×16

• Ignition table 12×12

• USB connector

• Wideband lambda controller (www.breitband-lambda.de)

• Supports low impedance injectors

• Supports stock idle valves

• User-programmable relay output

• Electronic boost control

• Tacho output

• Supports CAN bus

• Compatible with lambda sensor LSU 4.2

Scope of delivery:

• kdFi V1.4 Plug and Play ECU

• USB cable

• kdFi manual

• From 01.05.24 no CD included, software CD available for download under available downloads