kdFi V1.4 PNP BMW M40

500.00 560.00 

The kdFi V1.4 is installed in a Motronic compatible housing and loaded with an initial setup for M40 engines.
(not for the E36 with 88-pin control unit)
The control unit can be used on the following Bosch Motronics:
0 261 200 157
0 261 200 174
0 261 200 387
0 261 200 989
If your number is not listed, please contact us, using the contact form.

Customer to do:

  • Replace Throttle Position Switch with Throttle Position Sensor e.g. from M50 engine (not included in delivery)
  • Change Engine Management
  • START ENGINE!

Features:

  • MAP sensor based setup (can be changed to alpha-N via software)
  • Also suitable for turbo and compressor conversions
  • Fully compatible with MSextra Software
  • Build your own setup
  • MS2 onboard / Firmware MS2extra
  • Fuel Table 16×16
  • Ignition Table 12×12
  • USB Connector
  • Wideband Lambda controller
  • Prepared for single coils (separate wires need to be connected)
  • Supports stock idle valves
  • User-programmable relay output
  • Electronic boost control
  • Supports CAN Bus
  • Compatible with the Lambda Sensor LSU 4.2

Scope of delivery:

  • kdFi V1.4 Plug and Play ECU
  • USB Cable
  • kdFi Manual
  • From 01.05.24 no CD included, download software CD under available downloads ( HERE )
Additional information
Variant

With Bluetooth

,

Without Bluetooth