- Wiring harness assembly
- ECU installation services
- ECU configuration service on a hub dyno (in Tartu and Tallinn)
- Documentation of dyno results
- Building racecars
- Welding of safety cages
- Repair and maintenance of passenger cars
- Pre-purchase inspection of the vehicle
- Wheel alignment services
- Product sales in the online store and on-site
- Stainless steel and aluminum welding
- Exhaust system construction
- Other custom solutions
- 3D scanning and printing

kdFi V1.4 PNP BMW M20
500.00 € – 560.00 €

kdFi V1.4 PNP BMW M40
500.00 € – 560.00 €
kdFi V1.4 PNP BMW M30
Igakuine makse alates 8.33 €
500.00 € – 560.00 €
The kdFi V1.4 is installed in a Motronic compatible housing and loaded with an initial setup for M30 engines.
Also note our new and further developed product: UAB BMW M30
The control unit can be used for the following Bosch Motronics:
0 261 200 150
0 261 200 151
0 261 200 178
0 261 200 179
If your number is not listed, contact us using the contact form.
Customer to do:
- Replace Throttle Position Switch with Throttle Position Sensor e.g. from M50 engine (not included in delivery)
- Change Engine Management
- START ENGINE!
Features:
- MAP sensor based setup (can be changed to alpha-N via software)
- Also suitable for turbo and compressor conversions
- Fully compatible with MSextra Software
- Build your own setup
- MS2 onboard / Firmware MS2extra
- Fuel Table 16×16
- Ignition Table 12×12
- USB Connector
- Wideband Lambda controller
- Prepared for single coils (separate wires need to be connected)
- Supports stock idle valves
- User-programmable relay output
- Electronic boost control
- Supports CAN Bus
- Compatible with the Lambda Sensor LSU 4.2
Scope of delivery:
- kdFi V1.4 Plug and Play ECU
- USB Cable
- kdFi Manual
- From 01.05.24 no CD included, download software CD under available downloads ( HERE )
Additional information
Variant |
With Bluetooth ,Without Bluetooth |
---|